Starter - Husqvarna 325L Workshop Manual

6.7 Starter

6.7.1 To disassemble the starter unit
1. Remove the 8 screws and remove the starter unit.
2. Pull out the rope approximately 30 cm /12 in and put
it into the notch in the pulley. Put your thumb on the
starter pulley.
3. Let the pulley rotate slowly rearward to release the
tension of the starter spring.
14 - Repair instructions
4. Remove the screw (A) and the drive disc (B).
5. Remove the starter pulley (C) together with the
starter spring (D).
WARNING: The spring can eject and cause
injury. Put on protective goggles.
6. Use pointed pliers to pull out the ends of the starter
rope from the starter pulley.
6.7.2 To clean and examine the starter unit
• Clean all components.
• Examine the starter rope. Replace the starter rope if
it is damaged.
A
B
C
D
1023 - 001 - 24.04.2019