Battery Charge Level; Overload Warning; Setting The Cutting Angle; Setting The Cutting Depth - Parkside PHKSA 12 A2 Translation Of The Original Instructions

Battery charge level

♦ The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Overload warning

♦ If the appliance is in danger of overloading,
the overload warning
appliance switches off .

Setting the cutting angle

You can select the cutting angle using the cutting
angle scale .
■ Undo the wing screw
preselector . Set the desired angle on the cutting
angle scale using the top edge of the raised
black metal part (see fig . C) . Retighten the wing
screw .
The left recess in the base plate is for a cutting
angle of 45° . (Fig. B)
Fig. C: Setting the cutting angle to 45 degrees

Setting the cutting depth

NOTE
► Select a cutting depth of approx . 3 mm more
than the thickness of the material . This ensures
that you achieve a clean cut .
♦ Undo the locking screw
cutting depth on the cutting depth scale
using the reference marks (see arrow in fig . D) .
Retighten the locking screw
■ 10 │ GB │ IE │ NI
lights up briefly . The
of the cutting angle
0
and set the desired
.
Fig. D: Setting the cutting depth

Working with the circular saw

1 . Switch on the appliance – as described in
"Switching on and off" – and then place it
with the front edge of the base plate
material .
2 . Align the machine using the rip fence
using a marked line .

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The cordless hand-held circular saw is mainte-
nance-free .
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ Never allow liquids to get into the appliance .
■ Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
■ The blade guard must always move freely and
close automatically . Therefore, keep the area
around the blade guard clean at all times . Re-
move dust and chips by blowing them out with
compressed air or with a brush .
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
on the
or by
PHKSA 12 A2