Playback Modes; Continuous Playback; Single-Track Playback; Program Playback - Tascam CD-RW900CD Owner's Manual

Playback modes

There are four different playback modes. The selected
mode will be indicated on the left of the display.
≠ Continuous playback mode (default setting): no indi-
cation lamp
≠ Single playback mode: SINGLE lamp is lit
≠ Program playback mode: PROGRAM red lamp is lit
≠ Random playback mode: RANDOM red lamp is lit
The playback mode can be selected using the PLAY
MODE key on the remote control unit. Pressing the key
changes the playback mode on the display in the fol-
lowing order:
Continue ® Single ® Program ® Random
You can also select the playback mode using the PLAY
MODE option in the PLAY sub-menu (refer to "Opera-

Continuous playback

Programing is cancelled, and playback continuous in
the normal order.
1 During stop, set the Continue or the Mode>Cont
mode.

Single-track playback

This function enables playback of just a single track.
1 During stop, set the Single or the Mode>Single
mode.
2 Use the SKIP key or the number keys (0~9) on
the remote control to select the desired track.

Program playback

This function enables playback of selected tracks in any
desired order. Up to 99 tracks can be selected for pro-
gram playback.
1 During stop, set the Program or the Mode>Program
mode.
2 Use the number keys (0~9) on the remote control
unit to select each desired track for program play-
back, then press the ENTER key.
You can also rotate the MULTI JOG dial to select
the track number and push to enter.
The track number will be entered into the program.
Repeat the above step 2 until the desired program is
completed. As the program is being created, the pro-
gram number and total program playing time is revised
on the display.
NOTE
If the CLEAR key is pressed, the programmed track will
be deleted from the last.
4−Playback operations 1-Introduction
tion basics" on page 14). Turning the MULTI JOG dial
clockwise changes the playback mode shown on the
display in the following order:
Mode>Cont ® Mode>Single ® Mode>Program ®
Mode>Random
Pressing the MENU key or pushing the MULTI JOG
dial returns to normal mode from the menu mode.
While the mode can be changed from any playback
mode, the explanation in this manual will assume the
user is starting from the Continuous mode.
NOTE
The selected playback mode remains after power is
turned off. However, the setting of program playback
mode will be deleted when power is turned off.
2 Press the PLAY key to begin playback in order of
the track number.
The MULTI JOG dial can be used to select the
track also.
3 Press the PLAY key to begin playback.
After the selected track finishes, playback stops.
3 When program setting is completed, press the
PLAY key to begin playback of the tracks in the pro-
grammed order.
NOTE
≠ If the STOP key is pressed without first pressing the
PLAY key, all the program data will be erased.
≠ During stop, if the playback mode is switched to an-
other, all the program data will be erased.
≠ The programmed play order is not memorized when
power is turned off.
≠ In this mode, if any track is not programed, the CD-
RW900 will not start playback.
≠ If an attempt is made to enter more than 100 pro-
gram steps, the message PGM Full! appears on the
display.
≠ If the total program playing time exceeds 999 min 59
sec, --- : -- appears on the display.
17
TASCAM CD-RW900