Windscreen/Rear Window Wiper - Fiat 500L Owner's Handbook Manual

WINDSCREEN/REAR
WINDOW WIPER
162) 75)
REPLACING THE
WINDSCREEN WIPER
BLADES
Proceed as follows:
❒ raise the wiper arm, press tab A fig.
151 of the attachment spring and
remove the blade from the arm;
❒ fit the new blade, inserting the tab
into the special slot in the arm, making
sure that it is locked;
❒ lower the wiper arm on the
windscreen.
151
REPLACING THE REAR
WINDOW WIPER BLADE
Proceed as follows:
❒ raise cover A fig. 152, undo nut B
and remove arm C;
❒ correctly position the new arm, fully
tighten the nut B then lower the cover
A.
152
SPRAY NOZZLES
Windscreen washer
The windscreen washer jets A fig. 153
are fixed. If there is no jet of fluid, firstly
check that there is fluid in the reservoir
(see paragraph "Checking fluid levels"
in this chapter). Then check that the
nozzle holes are not clogged; use
F0Y0114C
a needle to unblock them if necessary.
153
Rear window washer
The rear window washer jets are fixed.
The nozzle holder is located on the
rear window fig. 154.
F0Y0208C
154
WARNING
162) Driving with worn windscreen/rear
window wiper blades is a serious hazard,
because visibility is reduced in bad
weather.
F0Y0209C
F0Y0210C
155