Tuning Your Trx 2.5R Racing Engine; High-Speed Fuel Mixture Adjustment - Traxxas Revo 5310 Owner's Manual

The TRX 2.5R Racing Engine

Tuning Your TRX 2.5R Racing Engine

The engine's performance depends on the fuel mixture. Turn the mixture
When tuning for
needles clockwise to lean the fuel mixture and counterclockwise to
performance, watch closely
to notice when there is no
richen it. Leaning the fuel mixture will increase engine power up to the
longer any increase in speed
engine's mechanical limits.
or power when the
fuel flow). Never lean the engine until it begins to cut-out or stall.
high-speed mixture is lean.
Leaning the engine beyond the safe allowable limits will result in poor
If you lean the high-speed
mixture to the point that the
performance and almost certain engine damage. Indications of an
engine cuts-out, hesitates,
overly lean mixture include:
or stalls, you are well into
the danger zone and engine
damage is likely. Richen the
high-speed needle 1/4 turn
and retune.
If any of these conditions are present, stop immediately and richen the
high speed mixture 1/4 turn. The engine will probably be slightly rich at
that setting and you can then retune for performance. Always tune for
For your convenience, the
low-speed needle has a
performance by starting rich and moving leaner toward the ideal setting.
positive stop that prevents
Never try to tune from the lean side. There should always be a light
it from being over tightened
stream of blue smoke coming from the exhaust.
and damaging the needle
and seat. This also provides
Before you begin tuning, the engine should be warmed up to its normal
an easy way to gauge how
operating temperature and running slightly rich. All final tuning
many turns out from closed
the low-speed needle adjustments must be made to the engine at its normal operating
adjustment is set to.
temperature. You can tell the engine is running rich by noting any of the
following:

High-Speed Fuel Mixture Adjustment

With the engine warm and running at a rich setting, gradually lean the
high-speed fuel mixture in 1/16 turn increments. Make several high-
speed passes with Revo after each adjustment to clear out the engine
and note any change in performance. The TRX 2.5R is extremely
powerful. Remember to apply the throttle gradually to prevent wheelies
30 • Revo
Never run the engine too lean (not enough
Cutting out or sudden loss of power during acceleration.
Overheating (temperature beyond 270° F at the glow plug)
Little or no blue smoke coming from the exhaust.
Sluggish acceleration with blue smoke coming from
the exhaust.
Revo may not shift into second gear
There is unburned fuel spraying from the exhaust tip
Leaning the high-speed fuel mixture increases performance
or loss of control. Continue this procedure until there is no longer any
performance improvement. If any one of the following conditions occurs,
the fuel mixture is already past the maximum safe lean setting:
1. There is no longer any performance improvement
2. The engine begins to cut out at high speed (Danger!)
3.
There is a sudden loss of power during acceleration (Danger!)
4. The engine begins to overheat. Symptoms of overheating include:
Steam or smoke coming from the engine (not exhaust)
Hesitation or stalling during acceleration
Popping or clattering sound when decelerating (detonation)
Fluctuating idle speed
Temperature measurement above 270° F at the glow plug
Richen the fuel mixture to the optimum setting by richening the high-
speed needle at least 1/8 turn counterclockwise and retest. This setting
will extend engine component life.