Tc Chase Menu; Tc Generator Menu; Midi Menu - Tascam DA-78HR Owner's Manual

4 - Menu interface, etc.

4.8 TC chase menu

The following parameters are
used to control the DA-78HR operations when chas-
ing to an incoming timecode signal:
V alues
Display
(*=default)
* (off),
(individual record-
ing)
Enabling individual recording while chasing
(rechase mode)
(rechase),
(free)
Rechase mode
*,
(rechase window)
or 2 seconds)
Width of rechase "window"
*,
(error bypass)
(10 or 30 frames)
Length of time for error bypass when chasing
*,
(park position
test)
Performs the park position test
* (0 sec-
(park position)
onds, 0 frames) to
(1 second,
29 frames)
Park position timing

4.9 TC generator menu

The following parameters are
used to control the internal timecode generator.
V alues
Display
(*=default)
* (external),
(TC recording
(TC genera-
source)
tor),
(tape timecode)
Selects the source of the timecode "stripe"
25
TASCAM DA-78HR
Described in
(on) 9.6.11, "Individual
recording while
chasing timecode"
* 9.6.9, "Rechasing
timecode"
(1 9.6.9, "Rechasing
timecode"
9.6.10, "Bypassing
timecode errors"
9.6.6, "Park posi-
tion"
9.6.7, "Automatic
park position set-
ting"
Described in
9.5.1, "Selecting
the timecode
source"
V alues
Display
(*=default)
* (off), (on)
(TC recording
enable)
Enabling of timecode recording
Time value in
(TC generator)
hh:mm:ss.ff
(00:00:00.00*)
Start time for on-board generator
* (reset),
(TC generator
(continue)
mode)
Restart mode for on-board generator
. * (stop),
(TC generator) (run)
Start/stop timecode generator

4.10MIDI menu

The following parameters are used
to control the MIDI parameters of the DA-78HR.
V alues
Display
(*=default)
*,
(MIDI)
Enables or disables MIDI (including MTC)
*,
(MIDI ID)
MMC ID
*,
(MTC)
MTC output
*,
(fast MTC)
MTC output in fast wind mode
*,
(stop MTC)
MTC output in stop mode
Described in
9.5.2, "Recording
timecode using the
generator"
9.5.2, "Recording
timecode using the
generator"
9.5.3, "Generator
modes"
9.5.2, "Recording
timecode using the
generator"
Described in
10.1, "MMC enable
and disable"
to 1 10.1.1, "Assigning
a MIDI ID to the
DA-78HR"
9.4.4, " MTC output"
9.4.4, " MTC output"
9.4.4, " MTC output"