Tascam DA-302 Owner's Manual page 10

0 ID-related display
Shows the indication for the deck selected by the
SELECT 1/2 key.
START WRT:
Lights when the Start ID Manual Writing mode is
selected.
START ERASE:
Lights when Start ID erasing is selected.
SKIP WRT:
Lights when Skip ID writing is selected.
SKIP ERASE:
Lights when Skip ID erasing is selected.
END WRT:
Lights when End ID writing is selected.
RENUM:
Lights when renumbering is selected.
START:
Lights when the Start ID is detected.
SKIP:
Lights when the Skip ID is detected.
END:
Lights when the End ID is detected.
q Sampling frequency display
... When an analog signal is being recorded, the sam-
pling frequency (48.0k, 44.1k, 32.0k) selected by
the Fs switch is lit.
... When a digital signal is being recorded, the sam-
pling frequency (48.0k, 44.1k, 32.0k) of the input
signal is lit.
·When "DIGITAL" is selected with the INPUT
switch and recording is performed without dig-
ital signal input, 48.0k blinks.
... LP lights in the Long Play mode.
w Peak level meter
... Shows
the input
recording/record-pause/sampling monitor.
... The playback signal level is shown during play-
back.
... When the input or playback signal level surpasses
the full-scale level, the OVER section lights.
e Time-related display
ABS:
Lights when the ABS time is shown on the time
display.
PGM:
Lights when the PGM time is shown on the time
display.
REMAIN:
Lights when the REMAIN time is shown on the
time display.
r Repeat display
Shows the indication for the deck selected by the
SELECT 1/2 key.
REPEAT:
Lights in the One-Program Repeat mode.
ALL REPEAT:
Lights in the All-Program Repeat mode.
signal level during
Section 4 : Features and Controls
8
COMMON MODE switch
1 & 2:
Select to engage both Deck 1 and Deck 2 in the
Record or Play mode at the same time.
∑
1 2:
Continuous playback or recording on Deck 1 and
Deck 2.
OFF:
For independent operation of Deck 1 and Deck 2.
9
Fs switch
... When recording analog input signals, select the
sampling frequency (32k, 44.1k, 48k).
·When 32k is selected, the Long Play mode is
engaged.
·When recording digital input signals, the sam-
pling frequency is automatically determined
according to the input signals.
0
MARGIN RESET key
... Resets the margin value when pressed while the
margin value is shown in the program number/mar-
gin display.
·When holding this key pressed, the margin value
corresponding to each input signal is shown con-
tinuously.
... Shows the margin value for as long as it is pressed,
when pressed while the program number is shown
in the program number/margin display during play-
back.
q
INPUT level controls
Use to adjust the recording level.
w
SELECT 1/2 key
To select the control deck for Deck 1 and Deck 2 (ID
MODE key, EXECUTE key).
When setting the menu, use to select the deck as
required.
e
ANALOG INPUT switch
Set this switch when input signals are analog.
UNCAL:
To adjust the recording level with the INPUT level
controls.
CAL:
The input and output levels are fixed and the record-
ing level cannot be adjusted.
·For the specified input level, the level meter shows
-16 dB.
r
INPUT switch
Set this switch according to input signals.
ANALOG:
Select when input signals are analog.
DIGITAL:
Select when input signals are digital.
11