Specifications - Hitachi WP 12DM Handling Instructions Manual

MODEL
WP12DM: with charger and case

SPECIFICATIONS

POWER TOOL
Model
No-load speed
Capacity
Rechargeable battery
Weight
CHARGER
Model
Charging time
Charging voltage
Weight
STANDARD ACCESSORIES
1. Charger (UC14YFA) ................................................... 1
2. Plastic case ................................................................ 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES
(Sold separately)
1. Plus driver bit
Bit No.
No. 2
No. 3
2. Wood working drill: Code No. 959183
Optional accessories are subject to change without notice.
0 – 2600 min
ø3.5 – ø9.5 (Wood screw)
EB1220BL: Ni-Cd battery, 12 V (2.0 Ah 10 cells)
EB1220BL: Approx. 50 min. (at 20°C)
APPLICATION
Design for driving wood screw
BATTERY REMOVAL/INSTALLATION
1. Battery removal
CAUTION:
2. Battery installation
Code No.
992671
992672
CHARGING
Before using the oil pulse driver, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle.
2. Insert the battery into the charger.
CAUTION:
3. Charging
WP12DM
–1 (/min)
1.9 kg
UC14YFA
7.2 – 14.4 V
0.6 kg
Hold the handle tightly and push the battery latch to
remove the battery. (Figs. 1 and 2)
Never short-circuit the battery.
Insert the battery while observing its polarities (see
Fig. 2).
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals.)
Insert the battery firmly, in the direction shown in
Fig. 3, until it contacts the bottom of the charger
compartment.
If the battery is inserted in the reverse direction, not
only recharging will become impossible, but it may
also cause problems in the charger such as deformed
recharging terminal.
When inserting a battery in the charger, charging will
commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
English
6