Removing The Shelf Supports; Aqua Clean; Cleaning The Oven Door - Zanussi ZOB35905XU User Manual

• To clean the door gasket, refer to the general
information about cleaning.

REMOVING THE SHELF SUPPORTS

To clean the oven, remove the shelf supports.
CAUTION! Be careful when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
1
Install the removed accessories in the opposite
sequence.

AQUA CLEAN

This cleaning procedure uses humidity to help
remove remaining fat and food particles from the
oven.
1. Put 300 ml of water into the cavity
embossment at the bottom of the oven.
2. Set the function:
3. Set the temperature to 90 °C.
4. Let the oven operate for 30 minutes.
5. Turn off the oven and let it cool down.
6. When the oven is cool, clean it with a soft
cloth.
WARNING! Make sure that the
oven is cool before you touch it.
There is a risk of burns.

CLEANING THE OVEN DOOR

The oven door has two glass panels. You can
remove the internal glass panel to clean it.
CAUTION! Do not use the appliance
without the internal glass panel.
22
2
.
The direction in which you open the
door depends on your oven model.
You open the door from the right side
in some models and from the left side
in others.
1. Press the buttons at the sides of the door trim
(A) on the upper cover and pull it upwards to
remove it.
2. Hold the inner glass B tightly with both hands
and slide it upwards to remove it from its initial
position.
Make sure that you tightly hold glass B to
prevent the glass from falling.
3. Clean the door with a wet sponge and rub it
dry with a soft cloth. Do not use steel wool,
acids or abrasive cleaning agents because they
can damage the surface.
When the oven door is clean, install the glass panel
in the opposite sequence. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
frame on the screen-printing zones is not rough
A
B