Explains choke position. Upper sign indicates choke closed and the lower fully open. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS WARNING Always wear eye, head and ear protectors when using this unit. Do not touch the bit when running the engine.
2. Plug cap 3. Ignition Switch 4. Muffler 5. Chuck unit 6. Throttle trigger 7. Recoil starter 8. Gear case 9. Fuel tank cap 10. Fuel tank 11. Shift lever 12. Air cleaner 13. Hole for strap www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Owner’s Manual contacttanaka@tanaka-ism.com...
Therefore, continual and regular users should monitor closely the condition of their hands and fingers. If any the above symptoms appear, seek medical advice immediately. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Drilling safety • • • •...
Fuel • Always use branded 89 octane unleaded gasoline. • Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil (B)), only for the state of California at 50: 1. • Never use multi-grade oil (10 W/30) or waste oil.
NOTE! At this stage if the engine does not start, repeat procedure from 2 to 4. 5. After starting the engine, allow the engine about 2-3 minutes to warm up before subjecting it to any load. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Owner’s Manual contacttanaka@tanaka-ism.com...
Shift lever may not move unless engine is running. If so, turn drill chuck a little bit by hand. • The purpose of Lock control and Reverse control is mainly for easy removal of bit. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Owner’s Manual contacttanaka@tanaka-ism.com...
Page 8
Do not hit the chuck mount wrench. (Fig. 2-7, 7B) Stopping (Fig. 2-8, SB, SC) Gradually decrease the engine speed to an idle speed, and then slide ignition switch (1) to STOP position. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Owner’s Manual contacttanaka@tanaka-ism.com...
We would like to inform that the power drills TED-262L/R/HS of the US model, which carry the following label on the unit are different from the ones for other market in carburetor adjustment. Adjustment of Standard openings of L/H screws are not necessary. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Owner’s Manual contacttanaka@tanaka-ism.com...
Page 10
An air filter that has been used for some time cannot be cleaned completely therefore, it must regularly be replaced by a new one. A damaged filter must always be replaced. NOTE! (TED-210) Saturate the element in 2-cycle oil or the equivalent. Squeeze the element to distribute the oil completely and to remove any excess oil.
Cover the unit and store it in a dry area. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Fuel filter (Fig. 3-5) Remove the fuel filter from the fuel tank and inspect.
• Clean the air filter. Monthly maintenance • Rinse the fuel tank with gasoline. • Clean the exterior of the carburetor and the space around it. • Clean the fan and the space around it. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS Owner’s Manual contacttanaka@tanaka-ism.com...
NOTE! Equivalent noise level/vibration level are calculated as the time-weighted energy total for noise/vibration levels under various working conditions with the following time distribution : ½ idle, ½ full speed. www.tanaka-usa.com TED-210/TED-262L/R/DH/HS All data subject to change without notice. Owner’s Manual...
Page 14
Tanaka Kogyo Co., Ltd., 3-4-29 Tsudanuma, Narashino, Chiba, Japan Nous,soussignés, Noi, Der unterzeichnete, Nosotros, Declare under our sole responsibility that the product, engine drill model Déclarons sous notre seule responsabilité que le produit en question, perceuse modéle Dichiariamo sotto la nostra unica responsabilità che il prodotto, il mototrapano modello Erklärt unter, eigener Verantwortung, daB das Produkt, bohrmaschine modell...