Janome MC6700P Service Manual page 31

After adjusting the clearance between the upper feed link shaft and upper feed lower shaft,
adjust the horizontal position of upper feed dog.
Upper feed adjusting dial
Upper feed dog (center)
4mm
Presser foot
Upper feed
upper shaft
rear arm
Upper feed dog (2)
Setscrew
1. Attach the dual feed foot.
2. Turn the power switch on and select the straight stitch
#1 ( ). Set the zigzag width at "0".
3 Set the upper feed adjusting dial at "0".
4. Lower the feed dog and press the needle up/down
key twice to raise the needle. Turn the power switch
off.
* To initialize the feed dog position, be sure to press the
needle up/down key twice to raise the needle.
5. Lower the presser foot lifter, check the clearance. The
clearance between the dual feed foot and upper feed
dog should be 4 mm.
To adjust:
If the clearance is not 4 mm, adjust as follows,
6. Remove the top cover.
7. Loosen the setscrews (2 pcs.) on upper feed rear
arm.
8. Insert a 4 mm spacer between the upper feed foot
and upper feed dog (center). Tighten the setscrews
(2 pcs.).
9. Attach the top cover.
29