Storing Your Iron; Self-Cleaning; Care And Cleaning - Black & Decker AvantSteam AS385 Use And Care Book Manual

AS385Pub10000001628 4/4/05 2:40 PM
SURGE OF STEAM
• Horizontal
1. With the water tank filled to the MAX mark, turn the fabric-select dial
to at least setting 4 and wait for the temperature-ready light to go off.
2. To remove tough wrinkles, pump the
intervals for a concentrated blast of steam.
• Vertical
1. Hang the garment to be steamed on a clothes hanger.
(Curtains or drapes can be steamed once they are hung.)
2. Set the steam selector to the middle
3. Hold the iron close to, but not touching, the fabric.
4. Pull the fabric tight in your free hand and pump the
button as you move the iron over the fabric (F).
F
SPRAY
You can use spray at any setting.
1. Pull out the water-fill cover.
2. Fill water tank up the MAX mark.
3. Press the button to spray water as you iron.
4. If spray is weak, pump the button a few times.
EMPTYING WATER TANK AFTER IRONING (OPTIONAL)
1. Turn the fabric-select dial to
let it cool.
2. Pull out the water-fill cover to expose water hole.
3. Empty the water by holding the iron over a sink with the
tip pointing down. Water will empty out of water-fill
opening (G).
G

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified service
personnel.
CLEANING OUTSIDE SURFACES
1. Make sure iron is unplugged and has cooled completely. Wipe the soleplate
and outer surfaces with a soft cloth dampened with water add mild household
detergent. Never use abrasives, heavy-duty cleansers, vinegar or scouring pads
that may scratch or discolor the iron.
2. After cleaning, steam iron over an old cloth to remove any residue from the
steam vents.

SELF-CLEANING

To keep the steam vents free of any buildup, about once a month follow these
instructions.
1. Fill the water tank well below the MAX line.
2. Plug in the iron.
Page 12
button a few times at 5-second
position.
. Unplug the iron and
11
3. Turn the fabric-select dial to 6 and stand the iron on its heel rest. Allow it to
heat until the temperature-ready light goes off and comes on again.
4. Turn fabric-select dial to 0, unplug the iron and hold over a sink with the
soleplate facing down.
5. Turn the selector to
steam will come out of the steam vents (H). Keep the
selector in the
or until you feel all mineral deposits have been flushed
out. If necessary, rock iron side to side and front to back.
6. When finished, place the iron on its heel rest and plug it
H
in. Heat for about 2 minutes to dry out any remaining water.

STORING YOUR IRON

1. Unplug the iron and allow it to cool.
2. Check that the selector is set to .
3. Store vertically on its heel rest to prevent water leaking from the soleplate.
. Be careful, as hot water and
position until all the water has emptied
12