Table of Contents
Advertisement
Problem solving guide
Message
Clean out airways
lights up at the
end of a pro-
gramme.
Clean the fluff filter.
Check the airways.
lights up after a
programme has
been cancelled.
Fault F . If restart
fails, call Service
lights up after a
programme has
been cancelled.
48
Cause and remedy
The tumble dryer is not working correctly or econom-
ically. Possible causes: clogging caused by fluff or
detergent residue.
Clean the fluff filter.
Check and clean the air supply area.
Please see "Cleaning and care" for notes on clean-
ing.
To delete the message: Open the fluff filter flap for
at least 10 seconds while the tumble dryer is
switched on.
You have attempted to dry only a few items of vary-
ing size. A smaller item has been sucked into the
loading area in the door and is clogging the holes in
the laundry deflector.
To delete the message: touch the
trol.
Open the tumble dryer door.
Remove the item that is blocking the holes.
Always dry small, individual items together with
larger items.
If you are able to exclude all this, an even more major
problem has occurred. See below.
The system has been clogged by fluff or detergent
residue.
Clean the fluff filter and air channels.
Check the ducting to make sure the drying air can
be extracted without any obstructions.
Please see "Cleaning and care" for notes on clean-
ing. Always replace a damaged fluff filter.
To delete the message: touch the
trol.
There is no obvious cause.
Note the prompt in the display.
Touch the
OK
sensor control.
If the programme terminates again with the same er-
ror message, then there is a fault. Contact Miele Ser-
vice.
OK
sensor con-
sensor con-
OK
Hide quick links:
Advertisement
Table of Contents
