Usb Parameter Defaults - Symbol DS 3408 Product Reference Manual

8-4 DS 3408 Product Reference Guide
To set up the digital scanner:
Interface cables vary depending on configuration. The connectors illustrated in
The connectors may be different than those illustrated, but the steps to connect the scanner remain the
Note
same.
1. Connect the modular connector of the USB interface cable to the cable interface port on the digital scanner (see
the Interface Cable on page
2. Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port of the IBM SurePOS
terminal.
3. Select the USB device type by scanning the appropriate bar code from
4. On first installation when using Windows, the software prompts to select or install the Human Interface Device driver. To
install this driver, provided by Windows, click Next through all the choices and click Finished on the last choice. The digital
scanner powers up during this installation.
5. To modify any other parameter options, scan the appropriate bar codes in this chapter.
If problems occur with the system, see

USB Parameter Defaults

Table 8-1 lists the defaults for USB host parameters. To change any option, scan the appropriate bar code(s) provided in the Parameter
Descriptions section beginning on page 8-5.
See Appendix A, Standard Default Parameters
miscellaneous default parameters.
Note
USB Host Parameters
USB Device Type
USB Country Keyboard Types (Country Codes)
USB Keystroke Delay
USB CAPS Lock Override
USB Ignore Unknown Characters
Emulate Keypad
USB FN1 Substitution
Function Key Mapping
Simulated Caps Lock
Convert Case
1-4).
Troubleshooting on page 3-3.
for all user preferences, hosts, symbologies, and
Table 8-1. USB Host Default Table
Parameter
Figure 8-1
USB Device Type on page
Default Page Number
HID Keyboard Emulation 8-5
North American 8-6
No Delay 8-8
Disable 8-8
Enable 8-9
Disable 8-9
Disable 8-10
Disable 8-10
Disable 8-11
None 8-11
are examples only.
Installing
8-5.