Operation - Festool CTH 26 E/a Original Operating Manual

CTH
GB
[1-5] Hose store
[1-6] Handle
[1-7] SysDoc
[1-8] Hose diameter setting
[1-9] Suction power adjuster
[1-10] Switch
[1-11] Warning sticker
[1-12] Locking clip
[1-13] Dust container
[1-15] Brake
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.

In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
6.1 Initial operation

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Remove the accessories from the dust contain-
er [2-3] and the packaging!

Affix the accompanying sticker in your national
language over the text field on the warning sign
[1-11].

Insert the sealing plug [1-1] on the panel (see
Fig. [1a] ).

Place a filter bag or safety filter bag in the dirt
trap in accordance with statutory requirements
(see Chapter 7.7, 7.8).

Replace the top section [2-1] and close the
locking clips [2-2].

Attach the cable holder to the rear of the mobile
dust extractor (see Fig. [3]).

Connect the suction hose to the machine.
6.2 Switch on/off

Insert the plug into an earthed socket.
16
WARNING
Risk of injury from tools starting up unexpectedly

Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-10] serves as an on/off switch.
Switch position "0"
Appliance socket [1-4] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-4] is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-4] is connected to the power,
the mobile dust extractor starts when the connect-
ed tool is switched on.
7 Settings
7.1 Adjusting the hose diameter

Adjust the hose diameter adjuster [1-8] to
match the diameter of the connected hose.
 The monitoring devices will measure the air
speed in the extractor hose correctly as a result
(see chapter 7.9).
7.2 Connecting electric power tools
WARNING
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-4].
7.3 Connecting pneumatic tools
WARNING
Risk of injury

Switch off the air tool.
If the compressed air module [1-3] (496141) is in-
stalled, the automatic switch-on function of the
mobile dust extractor also works in combination
with pneumatic tools.