Checking The Engine Oil Level; Changing The Engine Oil; Replacing The Oil Filter - PEUGEOT METROPOLIS 2019 Owner's Manual

CHECKING THE ENGINE OIL LEVEL

FR
Too much oil will noticeably restrict the
vehicle's performance.
GB
DE 1
IT
ES
• Place the vehicle on its central stand on flat ground.
• Start the engine, let it run for a few minutes and then
NL
stop it.
• Wait a few minutes for the oil to stabilise
• Remove the cap/oil gauge (1).
• Wipe dry the filler cap/gauge and fit it back but do not
GR
screw it into the filler hole.
• Remove the filler cap/gauge and check the oil level.
• The oil level shall not be between the minimum (A) and
maximum (B) level marks without exceeding the latter.
SE
• Add oil if necessary.
PT
FI
DK
PEUGEOT METROPOLIS
20/24

CHANGING THE ENGINE OIL

We advise you to go to a registered
dealer for draining.
Oil contains substances which are
harmful to the environment. Your dealer is
equipped to dispose of used oil without
endangering the environment and in
B
compliance with current standards.
A
The engine must be drained when it is warm to allow the
oil to run easier.
• Park the vehicle on its stand.
• Put on protective gloves.
• Remove the cap/oil gauge.
• Remove the drainage cap and its seal (2) and allow the
oil to drip into a recipient.
• Insert the drain plug fitted with a new seal.
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole.
Engine oil
Quantity
• Fit the cap/oil gauge.
• Start the engine and let it run for a short while.
• Check and adjust the oil level if necessary.
• Check that the oil drain plug is sealed.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
2
SAE 5W40 Synthetic API
SL/SJ
2 l

REPLACING THE OIL FILTER

We advise you to go to a registered
dealer for draining.
Oil contains substances which are
harmful to the environment. Your dealer is
equipped to dispose of used oil without
endangering the environment and in
compliance with current standards.
3
• Remove the oil filter cartridge (3) using an oil filter
wrench.
• Lubricate the rubber seal of a new oil filter
• Fit a new cartridge tightened by hand and lock it with a
1/4 turn.
• If you use a socket type oil filter wrench with square
fitting for use with a torque wrench, tighten the filter to
14 Nm.