Samsung 6300 Series E-Manual page 21

Connecting to a Wireless Internet Network Manually
Network Network Settings
With networks that require a static IP address, you will need to enter the IP address, subnet mask,
gateway and DNS values manually to connect to the network. To get the IP address, subnet mask,
gateway and DNS values, contact your Internet Service Provider (ISP).
"
Refer to the "Dynamic versus Static IP Addresses" section for more information on dynamic IP and static IP
addresses.
1.
Select Wireless. The TV automatically displays a list of available wireless networks.
2.
Select the network (SSID) you want to connect to. If the wireless router doesn't appear in the list,
select Add Network, and enter the network's SSID manually.
3.
Enter the security key and select OK. If the selected network is not security-enabled, the TV
attempts to connect right away.
4.
Select Stop when the TV attempts to connect to the network. Once the network connection has
been interrupted, select
5.
In the IP Settings
Mask, Gateway, and
●
Use one of the following methods to enter the numerical values.
Set the numbers using the
Place a finger on the
the screen moves in the direction you moved the Samsung Smart Control. Press the
button to select numbers. Only use for Samsung Smart Control.
For general remote control, enter the numbers directly. (Availability depends on the specific
model and area.)
6.
The TV attempts to connect to the network again using the specified settings. A confirmation
message appears once a connection is established. Select OK.
"
The network connection speed may differ depending on the DNS server settings.
"
For details on the DNS server settings, contact the Internet service provider (ISP).
Connecting to a Wireless Internet Network with WPS
Network Network Settings
With wireless routers that support WPS (Wi-Fi Protected Setup) or PBC (Push Button Configuration),
it's possible to press a button on the router to connect the TV to the Internet.
"
This functionality is not available with wireless routers that do not support WPS. Check to see if your
wireless router supports WPS.
1.
Select Wireless. The TV automatically displays a list of available wireless networks.
2.
Select WPS(PBC)
minutes.
3.
The TV exchanges the network name (SSID) and security key automatically and then attempts to
connect to the Internet. A confirmation message appears once a connection is established. Select
OK.
IP Settings.
screen, set the IP setting
DNS Server values, and then select OK.
and
POINTER button and move the Samsung Smart Control. The pointer on
and then press the WPS or PBC button located on the wireless router within two
to Enter manually, enter the
buttons on screen.
IP Address, Subnet
POINTER