Watching Tv; Channel Selection; Volume Adjustment - Sylvania SSL2606 Owner's Manual

W
ATCHING TV

CHANNEL SELECTION

You can select the channel by using either [CH K / L ]
or Channel number buttons. How to select the
channel in each way is shown below.
POWER
1 1
4 4
7 7
- -
SETUP
BACK
VOL.
1
Using [CH K / L ], or Channel number buttons
and pressing [ENTER].
• Using [CH K / L ], change the channel.
• Same operation is available with [CHANNEL
K / L ] on the top panel of the main unit.
• When you select a channel, press the channel
number you want to view with Channel number
buttons. The selected channel will be displayed.
- When selecting analog channel 12
1 2
ENTER
- When selecting digital channel 12-1
Be sure to press [–] before entering the
minor-channel number.
1 2 -
• If the channel broadcasts NTSC and ATSC both
and you don't press [–], then you will receive the
NTSC channel only. The moment you press [–],
the lowest memorized digital channel will be dis-
played.
• When you press [CH RETURN], the previously
selected channel will be selected.
NOTE:
• In the DTV broadcasting, one channel sometimes broad-
casts multiple programs depending on the air time. In this
case, the main channel is called major channel and the
minor-channel is called minor channel.
About minor-channel broadcasting:
There may be different programs being broad-
cast on minor-channels through a single chan-
nel from ATSC. You can watch each minor-
channel program being broadcast by selecting
one of the minor-channels.
18
EN
INPUT
SLEEP
SELECT
2 2 3 3
5 5 6 6
AUDIO
8 8 9 9
STILL
0 0
SCREEN
MODE
ENTER ENTER
INFO
CH RETURN CH RETURN
CH CH
MUTE MUTE
1
ENTER
NTSC
18:00
18:30
CH4 19:00
19:30
20:00
: change automatically
: change manually by pressing [CH
on your remote control
NOTE:
"No Signal" will appear on the screen after the
•
minor-channel broadcast is over.
You will need to change the channel to continue
watching another TV program.

VOLUME ADJUSTMENT

This section describes how to adjust the volume
when viewing TV. The Mute function, which is use-
ful when you have a visitor or a phone call, will be
also described.
BACK
CH RETURN
VOL. VOL.
1
Using [VOL. X / Y ] or [MUTE].
[VOL. X / Y ]
• You can adjust the audio volume with [VOL. X / Y ].
• The volume bar is displayed at the bottom of
the screen when adjusting the volume.
• Same operation is available with [VOLUME
X / Y ] on the top panel of the main unit.
Volume 20
• The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
• Press [MUTE] on the remote control to mute
the sound.
• To release the Mute status, press [MUTE]
again or press [VOL. X / Y ].
Mute
• "Mute" is displayed on the screen for a few sec-
onds.
ATSC
CH4-1 No signal No signal
CH4-1 CH4-2 CH4-3
CH4-1 No signal CH4-3
CH4-1 CH4-2 No signal
/ ]
INFO
CH
MUTE MUTE