Kerf Plate Replacement; Adjustments; Machine Cleaning; Machine Storage - Metabo KGS 305 Original Operating Instructions

− Tighten motor fastening screws
crosswise.
Replace the plastic cover (71) and
3.
secure with the screws.
9.3

Kerf plate replacement

A Danger!
With a damaged table insert
there is a risk of small parts getting
stuck between table insert and saw
blade, blocking the
Replace damaged table inserts imme-
diately!
Unscrew kerf plate (74).
1.
2. Install new kerf plate.
74
9.4

Adjustments

Fence adjustment
Loosen locking screws (75) (six
1.
turns counter-clockwise minimum).
Loosen securing screws (76).
2.
3. Slide adjustable fence
toward the centre (77) and remove;
loosen the hexagon socket screw
underneath by approx. one turn.
Align fence (78) so that it is square
4.
with the saw blade when the rotating
table engages in the 0° position.
5. Tighten hexagon socket screws.
6. Install movable fence halves on
fence (77).
Tighten securing screws (76) until they
7.
do no longer project over the fence.
Tighten locking screws (75).
8.
Mitre angle indicator adjustment
Loosen screw (80) approx. one turn.
1.
Adjust pointer (79) until the indicated
2.
value corresponds with the current
stop position of the rotating table.
Tighten screw (80).
3.
saw blade.
3
Note:
The rotating table engages in
positive stops at the 0°, 15°, 22.5°,
31.6°, 45°, and 60° position.
Bevel tilt positive stop adjustment
Engage track arm holder (81) at the
1.
0° position; do not tighten locking
lever (82).
halves
2. Loosen the two hexagon socket
head cap screws (83) at the rear of
the saw by approx. one turn.
75 76
77
78
3. Adjust the track arm holder until the
saw blade is at exactly 90° against
the rotating table.
4. Tighten the two hexagon socket
head cap screws (83) at the rear of
the saw again.
Tighten locking lever (82).
5.
Loosen screw (84) approx. one turn.
6.
7.
79 80
8.
positive stops at the 0°, 22.5° 33.9°, and
45° position.
9.5
Remove chips and saw dust with brush
or vacuum cleaner from:
− setting devices;
− operating elements;
81
− motor vent slots;
82
− space below table insert.
9.6
A
•
•
83 •
•
•
9.7
Prior to every use
•
•
•
ENGLISH
Adjust pointer (85) until the indi-
cated value corresponds with the
current stop position of the track arm
holder.
84
Tighten screw (84).
3
Note:
The track arm holder engages in

Machine cleaning

Machine storage

Danger!
Store saw in such way that it can
not be started by unauthorized
persons.
Safeguard the saw with a pad-
lock.
Make sure that nobody can get
injured by the stored machine.
A
Caution!
Do not store saw unprotected
outdoors or in damp environ-
ment.
Observe the permissible ambient
conditions (see "Technical Speci-
fications").

Maintenance

Remove saw dust and chips with
vacuum or brush.
Check power cable and power cable
plug for damage; if necessary have
damaged parts replaced by a quali-
fied electrician.
Check all moving parts to see that
they can move freely across their
whole range of travel.
85
27