Copying A Video Tape; Back Of Tv - Sylvania SRDD495 Owner's Manual

Copying a Video Tape

Warning: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.
(Back of another source)
DVD/VCR VCR
or
COMPONENT AUDIO OUT AUDIO IN
VIDEO OUT AUDIO OUT
Y L
C R
B
VIDEO OUT VIDEO OUT VIDEO IN
C
R
1) Insert a pre-recorded tape into the playing VCR.
2) Insert a tape with its record tab into the recording unit.
3) Press [SPEED] on the remote control of the recording unit to select the desired recording speed (SP/SLP).
4) Select the "L1"or "L2" position on the recording unit.
• To use the input jacks on the back of this unit, select "L1" position by pressing [0], [0], [1] on the remote control or
[CHANNEL K K /L L ].
• To use the input jacks on the front of this unit, select "L2" position by pressing [0], [0], [2] on the remote control or
[CHANNEL K K /L L ].
5) Press [REC/OTR] on the recording unit.
6) Begin playback of the tape in another source.
7) To stop recording, press [STOP/EJECT C C /A A ] on the recording unit, then stop playback of the tape in another source.
Hint
Hint
• For best results during dubbing, use the front panel controls whenever possible. The remote control might affect another source's operation.
• Always use video-quality shielded cables with RCA-type connectors. Standard audio cables are not recommended.
• You can use a video disc player, satellite receiver or other audio/video component with A/V outputs.
• "L1" or "L2" is found before the lowest memorized channel. (Example: CH02)
• "L2" input jacks are on the front of this unit.
1
DVD
ANT-IN DIGITAL AUDIO S-VIDEO
AUDIO OUT OUT OUT
L
Connect
L
R
ANT-OUT
COAXIAL
R
Audio/Video cables
(not supplied)
(Back of Recording DVD/VCR*)
DVD/VCR VCR
COMPONENT AUDIO OUT
VIDEO OUT
ANT-IN
Y L
AUDIO IN
C R R
B
VIDEO OUT VIDEO IN
ANT-OUT
C
R
*Front input jacks are also available
– 14 –

(Back of TV)

2
Connect
RF cable
(supplied)
EN