Table of Contents
Advertisement
The message "CLE" ("CLEAN") will be displayed
throughout the drain cycle:
•
After a few minutes, 3 beeps indicate the end of
thecleaning cycle and "END" blinks on the display:
•
Switch off the dishwasher by pressing button "A"
(Figure 17).
•
Switch off at the mains.
•
Close the water supply cock.
•
Replace the filter and the overflow.
Cleaning the nozzle jets
•
Remove the top and bottom jets "F" and "I",
unscrewing the ring nut "H".
H
F
C
Figure 23
•
Carefully clean the washing and rinse jets and
clean everything with hot water and neutral deter-
gent/detersive, if necessary using a soft brush or
sponge. Do not use sharp implements to clean the
nozzle holes, which could otherwise be damaged.
Cleaning the filter
Remove the filter "E" and clean away any remained
food.
E
Figure 24
16
Upon completion of cleaning operations, replace the
parts removed previously.
Cleaning the exterior surfaces
Before carrying out any cleaning operations, turn off
the power at the mains.
ATTENTION
Clean the stainless steel surfaces using warm
soapy water; never use detergents containing
abrasive substances nor steel scrapers, common
wire wool, brushes or scrapers; rinse thoroughly
using a wet cloth and carefully wipe dry.
Clean the control panel using a soft damp cloth
and a neutral detergent if necessary.
Do not wash the appliance using direct or high-
pressure water jets.
To reduce the emission of pollutants into the environ-
ment, clean the appliance (externally and where
necessary internally) with products having a biodegra-
dability of over 90%).
Leave the hood raised whenever the appliance is not
in use.
C5
A1
-
Check that the cock is open.
-
Check that the water inlet filter is clean.
-
Check the minimum mains pressure.
I
-
Check that the overflow pipe is inserted.
B1
-
Check if the overflow has been removed.
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
B2
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
C1..C8
E1..E8
-
Check if the overflow has been removed.
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
C6
The machine has several risks that were not com-
pletely eliminated from a design standpoint or with the
installation of adequate protection devices.
WARNING MESSAGES DISPLAYED ON THE
CONTROL PANEL
NO WATER
INEFFICIENT DRAINAGE
TANK WATER LEVEL TOO HIGH
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
RESIDUAL RISKS
Hide quick links:
Advertisement
Table of Contents
