Sylvania 6900DTD Owner's Manual page 22

Connections
STB connection to a standard stereo system
STEREO COMPONENT
1 Use a standard antenna cable to connect the wall jack to the ANT. IN jack on STB.
2 Use a standard audio cable to connect the audio output jacks (L, R) on STB to the audio input jacks (L, R)
on the stereo.
3 Connect STB and the TV with a video cable.
NOTE:
Refer to the pages describing the connection to TV.
4 Set the video resolution selection switch to "1080i."
NOTE:
For the capability of your TV and further information, refer to TV owner's manual.
5 Plug the AC power cord of the stereo into the AC outlet, then turn the stereo on.
6 Set the stereo to the input mode to which you connected the audio from the STB.
NOTE:
Refer to the stereo owner's manual for further information.
7 Plug the AC power cord of STB into the AC outlet, then turn STB on.
22
EN
NOTE:
Component video cable and audio cable are not included.
Audio cable
To audio input jacks
(L, R)
Rear panel of STB
Component video cable
To component video input
jacks (Y/ Pb/ Pr)