Advertisement
Installing the Z Stand
1. Place only 1 thrust washer onto the pivot pin (Figure 4).
Note: Do not use more that 1 thrust washer next to
the Z Stand tube.
2. Insert the pivot pin into the hub as shown in Figure 4.
Note: When inserting the pivot pin, make sure the
position of the slot in the Z Stand tube is as shown
in Figure 4.
3. Place as many thrust washers onto the end of the pivot
pin without forcing the lynch pin into the hole (Figure
4).
4. Install the lynch pin (Figure 4).
1. Z Stand
2. Pivot pin
3. Hub
Installing the Z Stand Bracket
1. Place the bracket on the left front frame as shown in
Figures Figure 5 and Figure 6.
2. Install the bracket the specific distance from the caster
frame as shown in Figure 5 and listed below.
52 inch mower decks = 127 mm (5 inches)
60/62 inch mower decks = 175 mm (6-7/8 inches)
72 inch mower decks = 248 mm (9-3/4 inches)
Note: The location to attach the bracket to the front
frame is determined by the mower deck size you have.
Figure 4
4. Thrust washer
5. Lynch pin
6. Slot in the tube
1. Left-front caster frame
2. Z Stand bracket
3. 127 mm (5 inches)—52
inch mower decks
3. Install the bracket with a bolt (5/16 x 3-1/4 inches)
and a lock nut (5/16 inch) (Figure 6).
4. Install the lanyard to the bracket pin. Use the large
loop on the lanyard (Figure 6).
5. Install the lanyard with a bolt (1/4 x 3/4 inches) and
lock nut (1/4 inch) (Figure 6).
1. Left front caster housing
2. Bracket
3. Bolt (5/16 x 3-1/4 inches)
4. Lock nut (5/16 inch)
3
Figure 5
4. 175 mm (6-7/8
inches)—62 inch mower
decks
5. 248 mm (9-3/4
inches)—72 inch mower
decks
Figure 6
5. Lock nut (1/4 inch)
6. Bolt (1/4 x 3/4 inches)
7. Lanyard
8. Bracket pin
Advertisement
