Advertisement
Description
Z Stand
Washers
Lynch pin
Hair pin cotter pin
Clevis pin
Bracket
Bolt (5/16 x 3-1/4 inches)
Lock nut (5/16 inch)
Bolt (1/4 x 3/4 inches)
Lock nut (1/4 inch)
Lanyard
Note: The following instructions are for installing the Z
Stand
®
on a 200 or 500 Series Z Master.
Assembling the Z Stand Hub
1. Install the bracket latch to the hub with a bolt (3/8 x
1-1/2 inches) and lock nut (3/8 inch) (Figure 1).
2. Tighten the lock nut and bolt. Then, unscrew it one
full turn or until the latch will freely rotate (Figure 1).
1. Bracket latch
2. Hub
Installing the Z Stand Hub
1. Place the hub on the right front frame as shown in
Figure 2 and Figure 3.
2. Install the hub assembly the specific distance from the
caster housing as shown in Figure 2 and listed below.
52 inch mower decks = 32 mm (1-1/4 inches)
60/62 inch mower decks = 70 mm (2-3/4 inches)
72 inch mower decks = 165 mm (6-1/2 inches)
Note: Note the location to attach hub to front frame
is determined by the size deck you have.
Figure 1
3. Bolt (3/8 x 1-1/2 inches)
4. Lock nut (3/8 inch)
Qty.
1
2
1
Install the Z Stand.
1
1
1
1
1
Install the Z Stand bracket.
1
1
1
1. Right front frame
2. Hub
3. 32 mm (1–1/4 inches)—52
inch mower decks
3. Install the hub to frame with 2 bolts (3/8 x 3-1/2
inches) and 2 lock nuts (3/8 inch) (Figure 3).
1. Right front frame
2. Hub
2
Use
Figure 2
4. 70 mm (2–3/4 inches)—62
inch mower decks
5. 165 mm (6-1/2
inches)—72 inch mower
decks
Figure 3
3. Bolt (3/8 x 3-1/2 inches)
4. Lock nuts (3/8 inch)
Advertisement
