Setting Up - Stihl FG 3 Instruction Manual

English

Setting Up

Adjusting the sharpening angle
Determine the sharpening angle
N
from the table below
Chain type Sharpening
angle
Rapid-Standard (RC...) 30°
Rapid-Micro (RM...) 30°
Rapid-Super (RS...) 30°
Picco-Micro (PM...) 30°
Picco-Super (PS...) 30°
Ripping
(RCX, RMX, PMX) 10°
3
Set sharpening angle (3)
N
The toothing of the clamping device is
5°.
16
5
4
Position the tooth head of the
N
master cutter (4) approximately
under the middle of the stop
roller (5)
Aligning the filing frame
6
Move the round file (6) downward
N
between the tooth face and depth
gauge of the master cutter by
swiveling and lifting the filing frame
7
Turn the adjusting screw (7) (anti-
N
clockwise – file lower, clockwise –
file higher) until approx. 1/4 of the
diameter of the sharpening file
protrudes above the tooth head
FG 3