Replacing The 2-Pane Glass Pack - Bosch Benchmark Series Service Manual

58300000187895 ARA EN A
Figure 7 Removing door liner screws
4. Lift the liner away from the rest of the door assembly and set
aside.
5. Remove the screws at the top left and top right, which secure
the handle to the door assembly.
6. Carefully lift the inner support frame with glass pack and
hinges away from the outer door glass/skin assembly and lay
flat on the work surface.
Figure 8 Removing inner support frame assembly
7. Lift the two pieces of insulation off the inner support frame
assembly and set aside.
8. Remove the screws on the upper right and lower left which
secure the hinges to the inner support frame.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
Figure 9 Location of screws securing hinges to inner support frame assembly
9. Lift the inner support frame upwards to access the hinges.
10. Install new right and left hinges and reassemble the door.
11. Test operation of the door by fully opening and closing it
several times.

7.1.4 Replacing the 2-Pane Glass Pack

 CAUTION
Wear protective gloves when disassembling the door. When replacing the
glass pack due to broken glass, exercise extra care to avoid injury from
broken glass.
To access the glass pack...
1. Remove the door as described in the Removing and
Reinstalling the Door section.
2. With the porcelain-coated door liner up, remove the two
screws on each side of the door liner.
3. Remove the screws along the bottom of the door assembly.
Figure 10 Removing door liner screws
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Page 15 of 36
800 944-2904