Cooling Fan - Bosch Benchmark Series Service Manual

58300000187895 ARA EN A
be entered by the customer from the Customer Settings menu to raise
or lower the cavity temperature during operation in modes other than
Broil, Convection Broil, Warm, Pizza or Self-clean.
The allowable Offset range is from 0°F to 35°F, positive or negative.
1. Press Settings to access the Customer Settings menu (from
stand-by mode only)
2. Press 9 for Temperature Offset.
3. Press Enter to edit the current setting.
4. Press (-) or (+) then enter the offset value using the numeric
keys - always enter the value as 2 digits (i.e, 05).
The new value is saved when the display changes from edit
mode back to display mode.
5. Press Clear On/Off to exit the Settings menu.
Example: A +25° offset will result in a cavity temperature of 350°
when the cooking temperature is set to 325° for any of the cooking
modes affected by the Offset. Similarly, a -25° offset will result in a
cavity temperature of 300° when the cooking temperature is set to
325°.
The adjusted temperature cannot be less than the minimum allowable
temperature for the cooking mode, nor higher than the maximum for
the cooking mode. See Allowable Operating Range by Cooking Mode
section.
4.3

Cooling Fan

The cooling fan is used to maintain allowable temperatures on internal
components and customer-accessible surfaces.
The cooling fan turns on low speed immediately at the start of a
cooking mode. The fan will continue to run for 15 minutes after the
mode has been cancelled.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
During Self-clean, the fan turns on high speed immediately at the start
of the cycle and will continue running for 15 minutes after the door
unlocks (@255°C/491°F).
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Page 10 of 36
800 944-2904