Simplicity Broadmotor Series Service & Repair Manual page 71

F
C
S
B
Figure 10. Electrical Component Locations
MAGNETO KILL CIRCUIT TESTS
13. Set the VOM to Ohms (checking continuity). Turn the
key switch to RUN. Disconnect the wire harness
from the interlock module.
14. Connect the negative probe to ground.
15. Probe the #5 plug (L). The VOM should show no
continuity. If the VOM shows continuity, the coil is
being shorted to ground through a broken wire or the
key switch.
D
A
7 Electrical System Service
J
K
I
H
E
7 - 15
Common Circuit Tests
G