Dimensions And Weight; Installing The 7316-Tf4 18.5-Inch Flat Panel Rack-Mounted Monitor And Keyboard - IBM 7316-TF4 Manual

Table 1. Console unit rack post distances
Rack configuration
No console switch
Provision for a console switch

Dimensions and weight

This topic provides the information about the dimensions and weight of the console unit.
The following table describes the console unit dimensions and weight.
Table 2. Console unit dimensions and weight
Height
Width
Depth
Bezel depth
Bezel width
Maximum forward extension
Weight
Installing the 7316-TF4 18.5-Inch Flat Panel Rack-Mounted Monitor and
Keyboard
This topic collection provides the information to install the 7316-TF4 18.5-Inch Flat Panel Rack-Mounted
Monitor and Keyboard console.
The console unit occupies 1U of mounting space in a rack. To install the console unit in the rack,
complete the steps in the following sections. Removing the rack doors and side panels, and removing the
rack devices that are above and below where you want to install the console unit, might make installation
easier.
See the documentation that comes with your rack for additional information.
Guidelines for rack mounting the console unit:
v Elevated operating ambient - If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment might be greater than room ambient. Therefore, consideration
should be given to installing the equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
v Reduced air flow - Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
v Mechanical loading - Mounting of the equipment in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical loading.
v Circuit overloading - Consideration should be given to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing
this concern.
6
Power Systems: 7316-TF4 18.5-Inch Flat Panel Rack-Mounted Monitor and Keyboard
Rack post distances
613 - 909 mm (24.1 - 35.8 in.]
706 - 909 mm (27.9 - 35.8 in.]
44 mm (1.75 in.) (display in stored position)
434 mm (17 in.) (main chassis only, slide-rails not
included, faceplate not included)
434 mm (17 in.) (chassis behind EIA mounting flange,
bezel in front of EIA flange not included,
cable-management arm not included)
35 mm (1.4 in.) (including latches and IBM Logo)
482 mm (19 in.) (includes latches)
650 mm (25.6 in.)
10.4 kg (23 lb)