Suzuki Automible 2008 Forenza Owner's Manual page 174

and the maximum pressure needed to
support that load. See "Compact
Spare Tire" in this section and "Load-
ing Your Vehicle" in section 4.
E. Tire Inflation Pressure
The temporary use tire or compact
spare tire should be inflated to 60 psi
(420 kPa). For more information on
tire pressure and inflation, see "Tire
Inflation Pressure" in this section.
F. Tire Size
A combination of letters and numbers
defining a tire's width, height, aspect
ratio, construction type and service
description. The letter "T" as the first
character in the tire size means the
tire is for temporary use only.
Tire Size
WARNING
Your SUZUKI is equipped with tires
which are all the same type and size.
This is important to ensure proper
steering and handling of the vehicle.
Never mix tires of different size or
type on the four wheels of your vehi-
cle. Mixing tires could cause you to
lose control while driving which may
lead to an accident. The size and type
of tires used should be only those
approved by SUZUKI Motor Corpora-
tion as standard or optional equip-
ment for your vehicle.
The following illustration shows an exam-
ple of a typical passenger car tire size.
A. Tire Type
This letter code indicates the primary
intended use of the tire. The "P" as
the first character in the tire size
means a passenger vehicle tire engi-
neered to standards set by the U.S.
Tire and Rim Association.
B. Tire Width
The three-digit number indicates the
tire section width in millimeters from
sidewall to sidewall.
C. Aspect Ratio
A two-digit number that indicates the
tire height-to-width measurements.
For example, if the tire size aspect
ratio is "70", as shown in item "C" of
the illustration, it would mean that the
SERVICE AND APPEARANCE CARE
tire's sidewall is 70% as high as it is
wide.
D. Construction Code
A letter code is used to indicate the
type of ply construction in the tire. The
letter "R" means radial ply construc-
tion, the letter "D" means diagonal or
bias ply construction; and the letter
"B" means belted-bias ply construc-
tion.
E. Rim Diameter
Diameter of the wheel in inches.
F. Service Description
These characters represent the load
range and the speed rating of a tire.
The load range represents the load
carrying capacity a tire is certified to
carry. The speed rating is the maxi-
mum speed a tire is certified to carry
a load. Speed ratings range from "A"
to "Z".
5-30