Unpacking; Contents Of Shipping Container - Powermatic 3520C Operating Instructions And Parts Manual

Read and understand the
entire contents of this manual before attempting
set-up or operation!
cause serious injury.

5.0 Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Lathe is assembled and
running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Some parts can be found in separate boxes packed
around the Lathe. Missing parts, if any, should be
reported to your distributor. Read the instruction
manual thoroughly for assembly, maintenance and
safety instructions.

5.1 Contents of shipping container

See Figure 5-1.
4 Levelers – A
2 Comparator centers – B
1 Spur center 1in. – C
1 Ball bearing live center – D
1 Knockout rod – E
1 Live center pin –F
1 Face plate 3in. – G
1 Tool support, 14in. – H
1 Face plate wrench – I
1 Tool caddy – J
1 Guard bracket – K
1 Comparator bracket – L
1 Locking handle – L
1
2 Leg assemblies – M
2 Riser blocks – N
1 Lathe bed, headstock, tailstock, banjo – O
1 Owner's manual (not shown)
1 Product registration card (not shown)
Fasteners:
4 Hex cap screws 1/2 x 2 – HP1
4 Lock washers 1/2 – HP2
4 Flat washers 1/2 – HP3
8 Socket hd. cap screws 3/8 x 1-3/4 – HP4
6 Socket hd. cap screws 3/8 x 1-1/4 – HP5
14 Lock washers 3/8 – HP6
10 Flat washers 3/8 – HP7
1 Lock handle – HP8
Failure to comply may
Figure 5-1: contents (not to scale)
7