Back Shell Installation - Sunrise Medical Quickie GTi Titanium None User Instruction Manual & Warranty

4
4. Ensure both side plates are at the same height
(A) by measuring to the bottom of the side plate
from a fixed location on the chair.
5. Adjust side plates to be parallel to push handles
when looking down on the side plates from
behind the chair. Tighten upper and lower
clamps on both sides.
NOTE– For 8-degree side plates adjust the side plate so
that the upper clamp fastener (B) is in the approx-
imately same location of the slot for both side
plates.
NOTE– It is Important to ensure that both left and right side
plates are installed at the same height and parallel to
the push handles. Check that all fasteners are tight
before moving on to the next step.
XT200005 Rev. B
I n s t a l l a t i o n
A
Figure 3
PARALLEL
Figure 4
B
Figure 5
I n s t a l l a t i o n

BACK SHELL INSTALLATION

Tools: 3/16 Allen wrench
1. Loosen the upper (A) and lower (B) connectors
by loosening the two fasteners that hold each
connector to the back shell.
CAUTION– Loosen both fasteners equally to allow the connec-
tors to freely slide back and forth but do not
remove the fasteners or loosen more than required
to achieve free sliding motion.
2. Place back shell onto chair by adjusting both
lower connectors to fit over pivot pins (C).
3. Adjust both upper connectors to fit into back
shell receiver (D).
A
B
Figure 6
E
D
C
Figure 7
XT200005 Rev. B
5