Installing A Single Headered (Sh) Filter; Installing A 2 In. Pre-Filter Combined With A Sh Final Filter; Figure 151 - Place The End Of The Latch Over The Filter Frame; Figure 152 - Correctly Installed Cartridge Filter - York SOLUTION XTI Series Installation And Assembly Manual

FORM 102.20-N1
ISSUE DATE: 7/06/2016
4. Install the other three latches into the corners.
5. Rotate all of the latches outward, and insert the
filter into the frame.
6. Grasp the loose end of the latch, and place it over
the filter frame so that the latch secures the filter
into the frame as shown in Figure 151 on page
99.
FIGURE 151 - PLACE THE END OF THE LATCH
OVER THE FILTER FRAME
7. Repeat the process with the remaining latches..
8. The filter should now be securely installed into
the frame.

Installing a Single Headered (SH) Filter

Use the following instructions to install a 2 in. Single
Headered (SH) filter into a 16 g galvanized hold-
ing frame with four latches (P/N 026-24788-702), as
shown in Figure 147 on page 95.
1. Install one latch at each corner (4 corners) of the
frame. The latch fits into two rows of three knock-
outs. Use the row of knockouts closest to the gas-
ket for nominal 1 in. filters or filters with a 13/16
in. single header. Use the second set of knockouts
for nominal 2 in. filters
2. Insert the straight end of the latch between the two
knockouts furthest from the corner.
JOHNSON CONTROLS
SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
3. Using a moderate amount of pressure, force the
latch over the third knockout. The latch should
now be trapped within the three knockouts, but
should be able to freely rotate.
4. The latch installation should be complete.
5. Rotate the latches outward, and insert the SH filter
into the frame. Insert the bulk of the filter through
the frame, protruding out the backside. Only the
header of the filter should be contacting the flange
of the frame.
6. After the filter is placed into the frame, grasp the
circular end of the latch and rotate it across the
corner of the filter.
7. Push the end of the latch towards the filter, until
the latch catches beneath the frame knockout.
8. Repeat the process with the remaining latches.
9. The filter should now be securely installed into
the frame as shown in as shown in Figure 152 on
page 99.
LD10179
FIGURE 152 - CORRECTLY INSTALLED
CARTRIDGE FILTER
Installing a 2 in. Pre-Filter Combined with a
SH Final Filter
Use the following instructions to install a 2 in. pre-
filter combined with a SH final filter (Multi-Cell FM
Single Header or Multi-Sak) into a 16 g galvanized
holding frame with four latches (P/N 026-35778-604),
as shown in Figure 147 on page 95.
1. Follow the instructions for the SH filters on the
previous page, and then proceed with the follow-
ing instructions for 2 in. pre-filters.
2. Insert the straight end of the latch between the two
knockouts furthest from the corner.
3
LD10148
99