Table of Contents
Advertisement
APPENdIx
Surround Sound
To take advantage of the TGM-100's Surround Sound
Audio Format, it is necessary to connect the audio output
to a device capable of decoding the surround sound signal.
•
If your digital TV can decode the signal, simply connect
it to the HDMI socket on the back of the TGM-100.
•
If your digital TV does not decode the signal, noise
will be emitted by the TV's speakers. In this case you
should mute the TV's volume and connect an amplifier
with this capability to the digital output (16) of the TGM-
100.
•
Check the
Output mode via the Admin UI
(see pg. 35).
Note: If none of the above suggestions resolves your con-
figuration problem, please contact your Dealer or Installer.
Warning messages
There are some scenarios in which the system may display
a warning message on the User Interface.
Automatic Shutdown
The TGM-100 contains sensors that continually monitor its
operating temperature. Should the temperature exceed
its maximum safe operating temperature, an automatic
shutdown will be initiated to prevent component damage
and subsequent data loss.
The User Interface will display the following warning
message:
When the countdown is complete, the unit will
automatically shutdown. When the unit is next switched
on, the following screen will be displayed:
44
If you see either of these screens displayed on the User
Interface, you should contact your dealer or installer as
soon as possible.
Look Up Failure
If the unit fails to return movie or album information from
the Internet upon inserting a disk, there are a number of
checks you can perform to help diagnose the problem.
•
Access the
Admin UI as described previously.
•
Navigate to the
Connection Settings screen via
the following path: Set Up > Settings > Connection
Settings.
•
Choose to display
View Assigned Ethernet Settings.
The User Interface will display the following screen:
•
Press the
ä Test button to display the Ethernet Tests
screen.
•
Press the
M Start button to run a series of quick
diagnostic tests.
If any of the tests fail, check the relevant settings, or the
hardware involved. If you are unable to resolve the issue,
contact your dealer or installer.
User's Manual
Advertisement
Table of Contents
