Table of Contents
Advertisement
Configuring Your Remote to Control
Other devices
The TV and Amp buttons on the remote control may be
individually configured to control a range of televisions,
receivers and amplifiers from well known manufacturers.
Configuring the Remote to Control a Television
•
Press the
TV and O Select buttons simultaneously;
hold them down for one second.
The TV button will remain lit for 20 seconds; the configura-
tion process must be completed during this time.
•
Enter the 3 digit numeric code matching the
manufacturer of your television from the list in Remote
Control Codes.
•
Press the
TV button again.
The TV button will blink twice to indicate that the configura-
tion has been accepted. If the TV button does not blink,
begin the process again, taking care to enter the number
exactly as printed in the list. If the television is switched on
during the configuration process, entering the correct code
will cause the television to go into standby.
To configure the remote to control your receiver or amplifi-
er, follow the above procedure, pressing the AmP button in
place of the TV button, and using the appropriate numeric
code for your amplifier.
User's Manual
CHAPTER 2 – Connections and Remote
Remote Control Use In a multi Room System
Your remote control may be configured to control additional
TGM-100C clients in the system.
Configuring the Remote with a Default Output
•
Press the
Audio Server and O Select buttons
simultaneously; hold them down for one second.
The Audio Server button will remain lit for 20 seconds; the
configuration process must be completed during this time.
•
Enter the 3 digit code corresponding to the output you
would like to control. For example, to set Output 2 as
your default output press: 0, 0, 2.
Audio Server button again.
•
Press the
The Audio Server button will blink twice to indicate that
the configuration has been accepted. If the Audio Server
button does not blink twice begin the process again, taking
care to enter the number correctly.
The remote control will now only control the first TGM-
100C client in the system. Additional remotes may be
programmed to control other clients using this method.
15
Advertisement
Table of Contents
