Introduction To Your; New R 3 • R 4 • R 4 V.v; Control Panel; Assembly - Robot Coupe R 3 Manual

INTRODUCTION TO YOUR

NEW R 3 • R 4 • R 4 V.V.
TABLE-TOP CUTTER MIXER
The R 3, R 4 or R 4 V.V. is perfectly geared to
professional needs. It can perform any number of
tasks, which you will gradually discover as you use it.
This machine can be used to process meat, vege-
tables, fine stuffing, mousse, grinding, kneading,...
in less than 5 minutes for even the longest tasks.
Its numerous functions will open the door to a whole
new culinary world.
Thanks to its simple design, all components requiring
frequent handling for maintenance or cleaning can
be fitted and removed in a trice.
This manual contains important information designed
to help the user get the most out of his or her cutter
device.
We therefore recommend that you read it carefully
before using your machine.
We have also included a few examples to help you
get the feel of your new machine and appreciate its
numerous advantages.
SWITCHING ON
THE MACHINE
• ADVICE ON ELECTRICAL CONNECTIONS
Before plugging in, check that your power supply
corresponds to that indicated on the machine's
identification plate.
W A R N I N G
This appliance must be plugged into an
earthed socket (risk of electrocution).
R 3 / R 4 Single Phase
The R 3 and R 4 are fitted with various types of
motors: 230 V / 50 Hz / 1
115 V / 60 Hz / 1
220 V / 60 Hz / 1
The machine comes with a single phase plug
connected to a power cord.
R 4 Three Phase
The R 4 comes with different types of motor :
400 V / 50 Hz / 3
220 V / 60 Hz / 3
This machine is supplied with a cable to which you
simply attach the appropriate electrical plug or iso-
lator for your system. The cable has four wires, one
earth wire, plus three phase wires.
If you have a 4-pin plug:
1) Connect the green and yellow earth wire to the
earth pin.
2) Connect the three other wires to the remaining
pins.
If you have more than 4 pins in the plug, please
note the ROBOT-COUPE does not require a neutral
wire.
Switch on the empty machine, making sure that
the blade is rotating properly in an anti-clockwise
direction.
On the motor unit, a red arrow marks the blade
rotation direction.
If the blade turns in a clokwise direction, swap over
two wires.
GREEN YELLOW is the earth,
DO NOT DISCONNECT
– —
Swap either : the and the
– ˜
the and the
— ˜
or the and the
R 4 V.V. Single Phase (Variable Speed)
The R 4 V.V. single phase models is available with a
motor + variable speed : 230 V / 50 - 60 Hz /1.
The standardized plug must be calibrated to a mini-
mum of 10 amps and preferably 16 amps, if the
appliance is used intensively.

• CONTROL PANEL

R 3 / R 4 Single Phase
Red switch = Off switch
Green switch = On switch
Black switch = Pulse control
R 4 Three Phase
Red switch = Off switch
Green switch = On switch
Black switch = Pulse control
Speed selector = 1500 or 3000 rpm.
R 4 V.V. : speed variation from 300 to 3000 rpm.
1) With the motor base
facing you, make sure
that the bowl is straight in
relation to the motor shaft,
with the magnetic bar
moved slightly to the left.

ASSEMBLY

17