How To Dsp/Usb Update - Pioneer DJM-5000 Service Manual

1

8.2 HOW TO DSP/USB UPDATE

A
Procedures for Updating
1. Updating of the DSP program (only when necessary)
2. Updating of the DSP data (only when necessary)
3. Updating of the TUSB (only when necessary)
4. Updating of the microcomputer
Note: After updating of the DSP and TUSB are completed, updating of the main microcomputer must be performed.
How to Update the Microcomputer
Note: Please turn power of DJM-5000 into OFF.
1. Start up QB-Programmer then perform the settings for the parameter file.
B
(The settings for the parameter file must be made only the first time. After the first startup, your settings will be stored
in memory. Later change in the settings is possible.)
How to set the parameter file:
Click on "Device" then "Setup" to display the "Device Setup" screen.
C
Select the appropriate parameter file for the chip on the "Device Setup" screen from the "Parameter File" list on the
"Standard" tab.
D
Click "OK" to finish the setup.
E
Parameter file for each microcomputer
Microcomputer
Main
Sub
F
42
1
2
Click
Parameter file Chip model number
78F1166.prm µPD78F1166
78F1164.prm µPD78F1164
DJM-5000
2
3
3
4
4