Package Contents; Prepare The Installation Site - NETGEAR ReadyNAS RR4360X Quick Start Manual

Package Contents

Important: Read all safety warnings in the hardware manual for your system before connecting
the system to the power supply.
Your package contains the following items:
• RR4360 chassis including 60 disk trays
• Rack mount rail kit
• Cable management kit
• Ten Power cords. (Five sets of two power cords for the two supplied power supplies. Each
set for a different region.)
• Ethernet cable
• 60 screws to optionally screw the disk trays to the disks

Prepare the Installation Site

Keep the following considerations in mind as you install your unit:
• Ambient operating temperature. If the unit is installed in a closed or multi-unit rack
assembly, the ambient operating temperature of the rack environment might be greater
than the ambient temperature of the room. Therefore, consider installing the equipment in
an environment compatible with the maximum rated ambient temperature.
• Reduced airflow. Mount the equipment into a rack so that the amount of airflow required
for safe operation is not compromised.
• Mechanical loading. Mount the equipment into a rack so that a hazardous condition does
not arise due to uneven mechanical loading.
• Circuit overloading. Consider the equipment's connection to the power supply circuitry
and the effect of possible overloading of circuits on overcurrent protection and power
supply wiring. Consider equipment nameplate ratings when addressing this concern.
• Reliable ground. This product requires that a reliable ground be maintained at all times.
To ensure this, ground the rack itself. Pay particular attention to power supply connections
other than the direct connections to the branch circuit (for example, the use of power
strips).
• Setup location. This product is intended for installation in a restricted access location
(dedicated equipment rooms, service closets, and the like) only.
• Front clearance. Leave enough clearance in front of the rack (about 64 cm or 25 inches)
to enable you to open the front door completely and in the back of the rack (about 76 cm
or 30 inches) to allow for sufficient airflow and ease in servicing.
• Rear rack clearance. This product requires nearly the full depth of the rack. Placement of
items such as a power strip inside the rack might block the product from being completely
pushed in.
3