Forms Insertion (3210 And 3215); Platen Removal And Replacement (3210 And 3215) - IBM System/370 145 Operating Procedures Manual

II
FORMS INSERTION (3210 and 3215)
• Do not use forms thicker than three part.
1. Place the forms on the lower rack of the forms stand.
2. Raise the top cover.
3. Move the forms load lever away from the keyboard.
4. I nsert the paper behind the platen and turn the platen
knob until the paper comes out in front.
5. Move the forms load lever toward the keyboard.
6. Guide the paper between the retaining clips and the
feed pins, making sure that the pins engage the margin
holes in the forms.
7. Position the paper for correct vertical alignment of the
first print line using the right platen knob.
8. Close the top cover.
9. Press the READY key.
II
PLATEN REMOVAL AND REPLACEMENT (3210 and 3215)
Removal
1. Press the NOT READY key.
2. Raise the top cover.
3. Move the forms load lever toward the keyboard.
4. Press down the platen latches at both ends of the platen
assembly and lift the platen out.
Platen Latch
30
Replacement
1. Position the platen with the ratchet teeth to the right.
2. Center the end plate in the groove at the right end of
the platen shaft and press the platen into place.
Platen Latch