Measurement Configuration Factory Settings; Import / Export - Hach ORBISPHERE 3100 User Manual

5.5.1 Measurement configuration factory settings

The following table shows the factory defined oxygen measurement configuration settings for
the instrument:
Instrument mode
Sample type
Gas unit type
Gas unit
High alarm
Low alarm
O2 measurement offset

5.6 Import / Export

This option allows you to export a number of different files (see
USB mass storage device. Once written to the USB device, it can then be used to load these files to
other 3100 instruments or to a PC.
Make sure a USB device is connected and then press the Enter key to start the process. A progress bar
is displayed at the bottom of the screen.
Wait until the export complete message is displayed on screen before removing the USB device.
This option allows you to import user tables from a USB mass storage device. These tables could be
exported from other 3100 instruments or from the 3100 software application installed on your PC. The
tables are recognized by having an extension of .ndu. If more than one table is found on the device, you
will need to select the table you want from the list.
Press the down arrow key to highlight the Import File option and press the Enter key to start the
process. You will need to restart the instrument before the new table takes effect.
This option allows you to import measurement configuration tables from a USB mass storage device.
These tables could be exported from other 3100 instruments or from the 3100 software application
installed on your PC. The tables are recognized by having an extension of .cdm. If more than one table
is found on the device, you will need to select the table you want from the list.
Press the down arrow key to highlight the Import File option and press the Enter key to start the
process. You will need to restart the instrument before the new table takes effect.
This option allows you to import solubility parameters from a USB mass storage device. The tables are
recognized by having an extension of .sol. If more than one file is found on the device, you will need to
select the file you want from the list.
Press the down arrow key to highlight the Import File option and press the Enter key to start the
process. You will need to restart the instrument before the new table takes effect.
This option allows you to import instrument user settings from a USB mass storage device. The tables
are recognized by having an extension of .ius. If more than one file is found on the device, you will need
to select the file you want from the list.
Press the down arrow key to highlight the Import File option and press the Enter key to start the
process. You will need to restart the instrument before the new table takes effect.
Note: To import files into the instrument from a USB mass storage device, they must be under a top-level
directory of 3100 for them to be recognized.
Instrument Settings
Continuous mode.
Beer
Dissolved
ppb
Disabled
Disabled
0.0 ppb
Export Files
Import User Table
Import Measurement Configuration Table
Import Solubility Parameters
Import Instrument Basic Settings
Main Menu
Exported files on page 36 for details) to a
35