Miele F 2411 SF Operating And Installation Instructions page 89

Table of Contents

Advertisement

Problem
The compressor is turn-
ing on more frequently
and for longer periods
of time; the temperature
in the appliance is too
low.
The compressor comes
on less and less often
and for shorter periods
of time. The tempera-
ture in the appliance
rises.
The door to the Freezer
Zone will not open be-
cause it has been
opened and closed too
many times in succes-
sion.
The compressor runs
continuously.
The temperature display
shows 0°F (-18°C), al-
though a higher temper-
ature is set.
Frequently Asked Questions
Possible cause and solution
The temperature setting is too low.
 Correct the temperature setting.
A large amount of food was put in for freezing at
once.
 See the information in the section on "Freezing
and storing food".
The SuperFrost function is still turned on.
 To save energy, you can switch the SuperFrost
function off early yourself.
This is not a fault. The temperature setting is too high.
 Correct the temperature setting.
 Check the temperature again after 24 hours.
The food begins to thaw.
The room temperature is too low for this appliance.
If the room temperature is too low, the compressor
will run less frequently. This may cause the freezer to
become too warm.
 See the "Installation location" section in the "In-
stallation information".
 Increase the room temperature.
This is not a fault. The suction caused by opening
and closing the door is preventing the door from
opening. Wait approx. 1 minute and then try again. It
should now open without force.
Not a fault. To save energy, the compressor runs at a
lower speed when less cooling is required. This in-
creases the compressor run time.
This is not a fault. When the ice maker is turned on
and the ambient room temperature is also low (< +
0°F (-18°C)) the temperature is automatically adjusted
to -0°F (-18°C). This guarantees that the ice maker
functions efficiently.
89

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

F 2801 sfF 2811 sfF 2901 sfF 2911 sf

Table of Contents