Storage States When Using Include-Credentials - HP 3500yl Series Access Security Manual

Type Factory Default
Manager/Operator Single set for switch
Passwords & port
Stored outside
access
config
Not displayed in
config file
SSH Public Key One set for switch
Stored in flash
Not displayed in
config
SNMPv3 auth and Stored in flash
priv
Not displayed in
config
RADIUS & TACACS Not displayed in
keystrings config
Note: When no include-credentials store-in-config is executed, the switch is restored to its default state and only stores
one set of operator/manager passwords and SSH keys.

Storage States When Using Include-Credentials

The following table shows the states of several access types when the factory
default settings are in effect or when include-credentials is enabled or not
enabled.
Include-Credentials
Enabled
One set per stored config
Stored in config
Displayed in config
One set per stored config
Stored in flash
Displayed in config
Stored in flash
Displayed in config
Stored in flash
Displayed in config
Configuring Username and Password Security
Saving Security Credentials in a Config File
Include-Credentials No Include-
Disabled but Active Credentials Executed
Same as include- One set for switch
credentials enabled
No credentials
Not displayed in config displayed in config
Same as include- One set for switch
credentials enabled
No credentials
Not displayed in config displayed in config
Same as include- No credentials
credentials enabled displayed in config
Not displayed in config
Same as include- No credentials
credentials enabled displayed in config
Not displayed in config
2-25