Water Filter (Mfwp); Water Filter (Xwp) - GE GYE18JBL Technical Service Manual

Bottom-freezer refrigerators
Table of Contents

Advertisement

Water Filter (MFWP)

MWFP Filter Cartridge Removal
• Slowly turn the filter to the left. Do not pull
down on the cartridge.
MWFP Filter Cartridge Installation
1. Fill the replacement cartridge with water
from the tap to allow for better flow from the
dispenser immediately after installation.
2. Line up the arrow on the cartridge and the
manifold. Place the top of the new cartridge
up inside the holder. Do not push it up into
the manifold.
3. Slowly turn it to the
right until the filter
cartridge stops. DO NOT
OVERTIGHTEN. The
cartridge will move about a
1/2 turn.
4. Run water from the dispenser for 1-1/2
gallons (about three minutes) to clear the
system and prevent sputtering.
5. Press and hold the Water Filter pad on the
dispenser board for three seconds.
NOTE: Remove the water filter to immediately
stop any water leak from the Icemaker/Dispenser
system. The water filter manifold acts as a cut-off
valve when the filter is removed and will prevent
further leaking.

Water Filter (XWP)

XWF Filter Cartridge Removal
1. Open the filter cartridge housing by squeezing
two front tabs and gently pull the cover down.
2. Rotate the filter down.
3. Grasp the filter and slowly turn it
counterclockwise about a 1/4 turn. The filter
should automatically release itself when it has
been rotated far enough to the left.
Filter Cartridge Installation
1. Follow XWF Filter
Cartridge Removal
steps.
2. Line the ports on the
filter with the ports of
the manifold, and gently
insert the filter.
3. Slowly turn the filter
to the right until it
stops. DO NOT
OVERTIGHTEN. The
filter will move about a
1/4 turn (90 degrees),
until the arrow on the
filter aligns with the
arrow on the manifold.
4. Slowly push the filter up
into the clips. Close the
filter cover by pushing
upwards on the cover
until the tabs lock into
place.
5. Run water from the dispenser for 2 gallons
(about five minutes) to clear the system and
prevent sputtering. If water is not flowing,
check to make sure the filter has been fully
rotated to the right.
6. Press and hold the Water Filter pad on the
dispenser board for three seconds.
NOTE: Remove the water filter to immediately
stop any water leak from the Icemaker/Dispenser
system. The water filter manifold acts as a cut-off
valve when the filter is removed and will prevent
further leaking.
– 43 –

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents