Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sunbeam 7620
Summary of Contents for Sunbeam 7620
- Page 1 Instruction Manual...
-
Page 2: Table Of Contents
Identification of Parts ............Notes for Proper Measurements . -
Page 3: Identification Of Parts
Identification of Parts... -
Page 4: Notes For Proper Measurements
--._--.-..-- . Notes for Proper Measurements ____ 1. Attach the arm cuff at the proper position of the arm as high as the level of th heart. 2. Do not. give vibration to the instrument during measurement, or proper measurement will not be achieved. -
Page 5: Description Of Display Marks
Description of Display Marks Display mark Measurement in Exhaust Insufficient pressure Replace batteries PUL Err Pulse error Exhaust speed flashing (exhaust speed error) Corrective action Adjust exhaust speed to 2 to 5mmHg/s... -
Page 6: Preparation For Measurements
Preparation for Measurements 1. Installing Batteries Remove the battery cover and insert batteries into the battery compartment as shown, taking extreme care that the polarities @ and 8 are observed. 2. Attaching the Arm Cuff Wind the arm cuff around the left upper arm tightly so that the bot- tom edge of the cuff is positioned one inch above the elbow joint. -
Page 7: Measurements
1. Turn Power ON 0 When power is turned ON, all display marks appear for approxi- mately 1 second. When the " 0 " " is displayed the unit is ready for measurement. If the V mark appears, release air with the air release button until "... - Page 8 @ When the measurement and buzzer sounds (beep), Systolic pressure is displayed on the left and Diastolic pressure on the right. 2 or 3 seconds later, pressure value and pulse appear alternate- ly on the display. 0 When a measurement is made with insufficient pressure the "...
-
Page 9: Exhaust Velocity
1. The exhaust velocity is the rate of gradual pressure drop from the pressure applied manually using the rubber bulb. 2. The exhaust condition is displayed in the right portion of the display from the time of pressurization until the measurement mark starts flashing. -
Page 10: More About Blood Pressure Measurements
More About Blood Pressure Measurements How Is A Proper Measurement Made? Blood pressure varies according to the conditions prevailing time of measurement, so be sure to consider the following in order to obtain the most accurate measurements. 1 . In preparation for blood pressure measurement, should urinate and should remain relatively stilt for 10 to 15 minutes prior to measurement. -
Page 11: What Is Blood Pressure
More About Blood Pressure Measurements What is Blood Pressure? The blood pressure will reach its highest levels in the large arteries near the heart and drop off toward the peripheral areas of the cir- culatory system. The blood pressure varies in accordance with the beating of the heart, and when the heart contracts, squeezing the blood out, the pressure inside the blood vessels is said to be systolic, and when the heart expands, sucking the blood back in, the pressure of the blood... -
Page 13: Precautions
+ 10x - + 4o(o”c. less than 85% RH - 2o*c - + .55OC, less than 05% RH t44Cwx 7Wb 3qH)mrn APProx 200g Made in Japan for Hanson Scale Com- pany Division of Sunbeam Carp Highway 45 North Shubuta, MS 39360... - Page 14 Hanson Scale Company Division of Sunbeam Corporation, Purvis,MS 39475 If purchased in Canada, Return prepaid to: Sunbeam Corporation (Canada) Limited. 1040 Islington Avenue Toronto.
- Page 15 Notes/Notas...