Controls - Sony HDC-750A Operation Manual

2-2 Controls

2-1 Accessory Attachment Points
Right side
0 FILTER control
!¡ AUTO W/B BAL switch
1 Y/RGB switch
Selects the video signal output for the TEST OUT
connector.
Y: Output is the Y signal (this is the power-on
default)
RGB: Output is the component video signal(s)
selected by the R/G/B switch 2.
2 R/G/B (red/green/blue) switch
When the Y/RGB switch 1 is set to RGB, selects the
component video signal(s) to be provided as output to
the TEST OUT connector.
3 VF DISP (viewfinder display) switch
Turns on or off the displays (safety zone marker,
center marker, text displays) and menu screens on the
viewfinder screen.
ON: Text describing the camera's operation status
will be displayed on the viewfinder screen.
OFF: All viewfinder screen displays will be turned
off.
MENU: Setup menus will be displayed on the
viewfinder screen.
2-2(E)
Chapter 2 Location and Function of Parts
See "4-5 Setup Using the OPERATION Menu" on
page 4-10(E) for information on the setup menus and how to
use them.
4 CAMERA/VTR switch
Selects control signals sent to a VTR connected to the
camera. The operation of the VTR at the start of
recording for each setting is shown in the table below.
CAMERA VTR Function
OFF SAVE Turn off the camera power.
ON SAVE Camera power is on. When the VTR's
START button is pressed, recording will
begin after a few seconds.
ON STBY Turn on the camera power. When the
VTR's START button is pressed,
recording will begin immediately.
5 GAIN switch
Used to select the gain of the video amplifier based on
lighting conditions. The gain values for the L, M, and
H settings may be set using the menus. When shipped
from the factory, the values set are L = 0 dB,
M = 6 dB, and H = 12 dB.
1 Y/RGB switch
2 R/G/B switch
3 VF DISP switch
4 CAMERA/VTR switch
5 GAIN switch
6 OUTPUT/DCC switch
7 WHITE BAL switch
8 CANCEL button
9 MENU SEL control