Using The Remote Setup Wizard To Configure The Array - Dell EqualLogic PS-M4110 Installation Manual

Dell EqualLogic PS-M4110 Installation Guide

Using the Remote Setup Wizard to Configure the Array

You can use the Remote Setup Wizard (RSW), either for Windows or Linux, to configure the array.
The Remote Setup Wizard is located on the Host Integration Tools CD-ROM. The Host Integration Tools User
Guide provides detailed information about using the full capabilities of the Remote Setup Wizard.
Important!
The Remote Setup Wizard must be installed on a computer that has access to the same fabric, or blade switches,
where the PS-M4110 array is located. This means that a blade server in the same chassis will have a NIC port
that is intended to be an iSCSI initiator port. This NIC port must be on the same physical fabric and also have an
IP address configured on it with the same subnet that the PS-M4110 array is on.
Running the Remote Setup Wizard
To run the Remote Setup Wizard, follow these steps:
1. Log in to a system that has access to the PS-M4110 blade storage array.
2. Install the Remote Setup Wizard, if it is not already installed. Follow the instructions in the Host Integration
Tools documentation. You can obtain the Host Integration Tools CD-ROM from the shipping box, or
download the Host Integration Tools kit from the EqualLogic support web site (support.equallogic.com). See
the Preface on page v
3. Start the Remote Setup Wizard. The RSW startup method will depend upon the operating system.
4. In the Welcome dialog box, select
Note: If you cannot contact the array, check the network configuration. You may need to modify the net-
work configuration to access the array.
5. Select the array that you want to initialize and click
6. In the Initialize Array dialog box, enter the array configuration information from
create a group or join an existing group. Then, click
7. In the Create a New Group or Join an Existing Group dialog box, enter the group configuration from
and click Next .
8. Click to exit the wizard.
Finish
If you added the array to an existing group, you must set the member's RAID policy in order to use the disk
storage. Go to Setting the Member RAID Policy on page
If you created a new group, go to
40
for information.
Initialize a PS Series array
Chapter 5, Allocating
and click
Next .
Next .
41.
Storage.
Chapter 4 Configuring the Array
Next .
Table 5 and choose to
Table 6