5.2
Adding a CPU to the configuration
Note
The CPU does not have a pre-configured IP address. You must manually assign an IP
address for the CPU during the device configuration. If your CPU is connected to a router on
the network, you also enter the IP address for a router.
Easy Book
Manual, 11/2011, A5E02486774-04
Easy to create the device configuration
5.2 Adding a CPU to the configuration
You create your device configuration by inserting
a CPU into your project. Select the CPU in the
"Add a new device" dialog and click "OK" to add
the CPU to the project.
The Device view shows the
CPU and rack.
Selecting the CPU in the Device view
displays the CPU properties in the
inspector window. Use these properties
to configure the operational parameters
of the CPU (Page 76).
73