Additional Information; Current Status; Resetting The System - BMW M2 Owner's Manual

CONTROLS
General information
Sensors in the tire valves measure the tire infla‐
tion pressure and, depending on the model, the
tire temperature.
Further information and instructions on using the
system can also be found under Tire inflation
pressure, refer to page 214.
Functional requirements
The following conditions must be met for the
system; otherwise, reliable flagging of a loss of
tire inflation pressure is not assured:
▷ After a tire or wheel replacement, a reset was
performed with the correct tire inflation pres‐
sure.
▷ After the tire inflation pressure was adjusted
to a new value, a reset was performed.
▷ Wheels with TPM wheel electronics.
Status display

Current status

The system status can be displayed on the Con‐
trol Display, e.g., whether or not the system is ac‐
tive.
Via iDrive:
1. "My Vehicle"
2. "Vehicle status"
3. "Tire Pressure Monitor"
The current status is displayed.
Tire conditions
General information
Tire and system status are indicated by the color
of the wheels and a SMS text message on the
Control Display.
142
Safety
Online Edition for Part no. 01402720665 - II/19
All wheels green
System is active and will issue a warning related
to the tire inflation pressures stored during the
last reset.
One to four yellow wheels
A flat tire or major drop in the tire inflation pres‐
sure has occurred in the indicated tires.
Gray wheels
It may not be possible to identify tire pressure
losses.
Possible causes:
▷ Malfunction.
▷ The system is being reset.

Additional information

The status control display additionally shows the
current tire inflation pressures and, depending on
the model, tire temperatures. The values shown
are instantaneous measurements and may vary
depending on driving style or weather conditions.

Resetting the system

Via iDrive:
1. "My Vehicle"
2. "Vehicle status"
3. "Tire Pressure Monitor"
4. Start the engine but do not drive off.
5. Reset tire inflation pressure: "Perform reset".
6. Drive away.
The wheels are displayed in gray and the follow‐
ing is displayed "Resetting Tire Pressure
Monitor...".
After a travel time of several minutes, the set tire
inflation pressures are accepted as reference val‐
ues. The reset is completed automatically while
driving.
After a successfully completed reset, the wheels
on the Control Display are shown in green and