Make Electrical Connection - Jenn-Air JIC4724HB Installation Instructions Manual

4. Start the hold-down screws into the hold-down brackets.
A
B
C
D
A. Countertop
B. Wood block
C. Hold-down screw
D. Hold-down bracket
E. Burner box
5. Center the cooktop in the opening and, using a wood block
between the screw and the countertop, moderately tighten
the screws to secure cooktop.
IMPORTANT: Do not tighten screws directly against the
countertop.

Make Electrical Connection

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This cooktop is manufactured with a frame-connected green or
bare ground wire. Connect the cooktop cable to the junction box
through the UL Listed or CSA Approved conduit connector.
Electrical Connection Options
And You Will Be
If Your Home Has:
Connecting to:
4-wire direct A fused disconnect
or circuit breaker
box
5"
(12.7 cm)
3-wire direct A fused disconnect
or circuit breaker
box
3¹⁄₂"
(8.9 cm)
E
Go to Section:
4-Wire Cable
from Home Power
Supply
3-Wire Cable
from Home Power
Supply - U.S.A.
Only
4-Wire Cable from Home Power Supply
IMPORTANT: Use the 4-wire cable from home power supply in
the U.S.A. where local codes do not allow grounding through
neutral, New Branch circuit installations (1996 NEC), mobile
homes and recreational vehicles, New constructions, and in
Canada.
A
B
C
D
A. Cable from home power supply
B. Red wires
C. Green (or bare) ground wires
D. 3-wire cable from cooktop
E. Junction box
1. Disconnect power.
2. Remove junction box cover, if present.
3. Connect the 2 red wires (B) together using a UL listed wire
connector.
4. Connect the green (or bare) ground wire (C) from the cooktop
cable to the green (or bare) ground wire (in the junction box)
using the UL listed wire connectors.
5. Put a UL listed wire connector on the end of the white
wire (F).
NOTE: Do not connect the green (or bare) ground wire to the
neutral (white) wire in the junction box.
6. Connect the 2 black wire (H) together using a UL listed wire
connector.
7. Reinstall junction box cover.
E
F
G
H
I
F. White wire (from home power
supply)
G. UL listed wire connector
H. Black wires
I. UL listed or CSA approved
conduit connector with wire
bushing
7