Wireless Systems - NAPCO Gemini GEM-P816 Installation Instructions Manual

Page 12
After installation is completed, test the system as follows.
1. Call the central station to inform them of the test.
2. Initiate an alarm, preferably on a zone that activates a steady siren, and verify proper signalling.
3. Call the central station to confirm their receipt of a good transmission.
Note: Be sure to test all enabled keypad panics.
Signal Strength Testing/Wireless Systems
To test the operation of wireless transmitters, proceed as follows. (Note: Wireless systems have not been investigated by
UL.)
1. Enter the Fault-Find Mode.
2. Fault a point of the transmitter to be tested by opening the loop. If the signal strength of the transmitter is 3 or
greater, the keypad will beep.
3. Restore the wireless point (close the loop). If the signal strength of the transmitter is 3 or greater, the keypad will
beep.
The transmitter signal strength will be displayed on a scale of 3-10 with 3 considered marginal and 10 considered
excellent. If the signal strength is less than 3, the keypad will not beep and the strength will be displayed. Except in the
Fault-Find Mode, signal strengths less than 3 will be entered into the system log.
GEM-P816 Installation Instructions
WI994A 10/99
NAPCO Security Systems